HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
In the logical path definition for REVERSE index1, the index2 and
index3 port numbers are duplicated.
Delete one of the definitions or make sure that the duplicated port
numbers are correct, and then re-execute the command.
index1
Index number of the duplicated logical path
index2
Index number of one of the duplicated ports
index3
Index number of the other duplicated port
Duplicate ports exist in REVERSE.
YKZ274E MSG
SC=36 RC=36 (in-
dex1, index2, in-
dex3)
The route list or device number information, required for processing to
continue, is missing.
Correct the value assigned to the ROUTE, DAD or PATH parameter
passed to the YKLOAD command. Make sure that the specified volume
has been scanned, because this message is output when the volume
for CU and CCA specified in the path set definition file has not been
scanned.
Necessary Routelist or DEVN inform-
ation is not found.
YKZ275E MSG
SC=36 RC=36
A storage system using a path-controlled device or remote disk controller
control contains an IFType, which is not supported for disk
controller-type path control.
In the configuration file, make sure that the storage system is controllable
(that the first two digits of the IFType are X'11' or higher). Also, if
scanning was not performed after the storage system microcode was
replaced, perform another scan.
Some of the storage systems do not
support DKC type paths.
YKZ276E MSG
SC=36 RC=36
There is a logical path without a physical path established.
Some paths are in the NOPATH
state.
YKZ277W MSG
SC=4 RC=4
Logical paths were detected for which the port information stored in
the REXX variable did not match the port information set on the storage
system. The port number or number of ports that have been set is incor-
rect.
Some paths are in the MISMATCH
state.
YKZ278W MSG
SC=8 RC=8
Logical paths containing physical paths in the INVALID status were
detected from a storage system.
Some paths are in the INVALID state.
YKZ279W MSG
SC=12 RC=12
Table 42 List of messages (message ID YKZ28x)
Explanation and recommended actionsMessage textMessage ID
The IFType of a storage system using the Remote DKC Control Function
is smaller than the IFType of the P-VOL defined in the copy group.
As such, the smaller of the two will be used when each command is
executed. Note that on some machine types, some functionality might
be lost. Also, if a scan was not performed after the storage system
microcode was replaced, perform another scan.
value
IFType value of the remote storage system
Primary volume's IFType is larger
than Remote control's IFType value.
YKZ280W MSG
SC=0 RC=0
Messages190