HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

4. Use a text editor to create a cluster configuration file on the active node and a cluster configuration
file on the standby node.
Specify the following items in the cluster configuration file for the active node:
mode=online
virtualhost=logical-host-name
onlinehost=active-node-host-name
standbyhost=standby-node-host-name
Specify the following items in the cluster configuration file for the standby node:
mode=standby
virtualhost=logical-host-name
onlinehost=active-node-host-name
standbyhost=standby-node-host-name
Save each file on its node as cluster.conf in
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\Base64\
conf.
NOTE:
• Specify online for the active node and specify standby for the standby node.
• For virtualhost, onlinehost, and standbyhost, an IP address cannot be
specified. Also, verify that an IP address can be resolved from the host name.
• The IP address that is assigned to the logical host name specified in virtualhost must be
enabled and accessible.
5. On both the active and standby nodes, open the server.properties file, and then specify
a logical host name for the server.http.host property.
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\
DeviceManager\Server\config\server.properties
HP XP7 Command View Advanced Edition server installation in a cluster environment94