HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

9. In the Services window, open the properties for the following services, and then change Startup
Type from Automatic to Manual:
• HBase 64 Storage Mgmt Common Service
• HBase 64 Storage Mgmt SSO Service
• HBase 64 Storage Mgmt Web Service
• HBase 64 Storage Mgmt Web SSO Service
• HCS Device Manager Web Service
• DeviceManagerServer
• HP StorageWorks XP Tiered Storage Manager
10. Upgrading from v 7.6.1 or earlier, add the HP XP7 Command View Advanced Edition service
to the resource group, and then bring the added resource group online.
For more information about installing HP XP7 Command View Advanced Edition in an environment
in which Replication Manager is linked with Business Continuity Manager, see the HP XP7
Replication Manager Administrator Guide.
Related topics
• Installing XP7 Command View AE on Windows, page 35
• Post-installation tasks (overwrite or upgrade), page 44
• Registering HP XP7 Command View Advanced Edition services, page 81
Changing from a non-cluster to a cluster environment
This section describes the procedures for changing the operating environment of a Device Manager,
Tiered Storage Manager, or Replication Manager system from a non-cluster to a cluster environment
after operation has started.
The Device Manager, Tiered Storage Manager, or Replication Manager server operating in a
non-cluster configuration is used for the active node in the cluster.
NOTE:
During cluster configuration, HP XP7 Command View Advanced Edition services are stopped.
Consequently, do not access HP XP7 Command View Advanced Edition while configuration is in
progress.
1. Install HP XP7 Command View Advanced Edition on the computer to be used as the standby
node.
2. Using the GUI, register the licenses for the products you want to use.
• Access the IP address of the standby node.
• A license key must be entered for each product that is installed.
3. From the active node, run the following command to change the URL for starting the GUI to the
logical host name:
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\Base64\bin\hcmds64chgurl
/change
http://IP-address-or-host-name-of-the-active-node:port-number
http://logical-host-name:port-number
Installation and Configuration Guide 93