HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

8. Run the following command to migrate the database to the shared disk:
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\Base64\bin\hcmds64dbclustersetup
/createcluster /databasepath target-folder-for-recreating-database/
exportpath target-folder-for-storing-database /auto
• createcluster
This option changes the HP XP7 Command View Advanced Edition product from a non-cluster
configuration to a cluster configuration.
• databasepath
Specify the folder in which you want to recreate the database. Use an absolute path to a
folder on the shared disk. The path name cannot exceed 63 bytes.
These characters can be specified in the path: A to Z, a to z, 0 to 9, period (.), underscores
(_). Additionally, backslashes (\), colons (:), or forward slashes (/) can be used as path de-
limiters.
CAUTION:
If you are upgrading from v7.6.1 or earlier, regarding the folder for re-creating the database,
specify a different folder than the one that you used before the upgrade.
• exportpath
Specify the folder in which you want to store the database. Use an absolute path to a folder
on a local disk. The path name must not exceed 63 bytes.
These characters can be specified in the path: A to Z, a to z, 0 to 9, period (.), underscores
(_). Additionally, backslashes (\), colons (:), or forward slashes (/) can be used as path de-
limiters.
• auto
Automatically stops or starts HP XP7 Command View Advanced Edition services.
NOTE:
• If you execute the hcmds64dbclustersetup command, the setting of the port number
used by HiRDB is changed back to the default (22032/tcp).
• If target-folder-for-storing-database already exists, empty or delete the
folder.
• Do not disconnect the shared disk from the active node until the hcmds64dbcluster-
setup command finishes successfully.
• If you restart the server after the hcmds64dbclustersetup command has finished
abnormally, the node to which the shared disk connects might switch to the standby node.
9. Stop the installed HP XP7 Command View Advanced Edition product services.
For details about stopping the services, see the manual that corresponds to the version of the HP
XP7 Command View Advanced Edition product that you are using.
Installation and Configuration Guide 89