HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

3. Open the server.properties file and verify that the logical host name is specified in the
server.http.host property.
If the logical host name is not set, change the current value to the logical host name.
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\
DeviceManager\Server\config\server.properties
4. To migrate the data to the shared disk, specify the database on the shared disk as the database
to be used.
The procedure is described in steps 5 through 6.
If a cluster environment has been configured for another HP XP7 Command View Advanced
Edition product, you do not need to do the procedure for migrating the database to the shared
disk and can proceed to step 7.
5. If HiRDB is currently using a different port number than the default (22032/tcp), make note of
the current port number.
6. Run the following command to migrate the database to the shared disk:
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\Base64\bin\hcmds64dbclustersetup
/createcluster /databasepath target-folder-for-recreating-database/
exportpath target-folder-for-storing-database /auto
• createcluster
This option changes the HP XP7 Command View Advanced Edition product from a non-cluster
configuration to a cluster configuration.
• databasepath
Specify the folder in which you want to recreate the database. Use an absolute path to a
folder on the shared disk. The path name cannot exceed 63 bytes.
These characters can be specified in the path: A to Z, a to z, 0 to 9, period (.), underscores
(_). Additionally, backslashes (\), colons (:), or forward slashes (/) can be used as path de-
limiters.
• exportpath
Specify the folder in which you want to store the database. Use an absolute path to a folder
on a local disk. The path name must not exceed 63 bytes.
These characters can be specified in the path: A to Z, a to z, 0 to 9, period (.), underscores
(_). Additionally, backslashes (\), colons (:), or forward slashes (/) can be used as path de-
limiters.
• auto
Automatically stops or starts HP XP7 Command View Advanced Edition services.
NOTE:
• If you run the hcmds64dbclustersetup command, the setting of the port number
used by HiRDB is changed back to the default (22032/tcp).
• If target-folder-for-storing-database already exists, empty or delete the
folder.
• Do not disconnect the shared disk from the active node until the hcmds64dbcluster-
setup command finishes successfully.
• If you restart the server after the hcmds64dbclustersetup command has finished
abnormally, the node to which the shared disk connects might switch to the standby node.
HP XP7 Command View Advanced Edition server installation in a cluster environment80