HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

6. Use a text editor to create a cluster configuration file. This step is not required if a cluster
environment has been configured for other HP XP7 Command View Advanced Edition products.
Specify the following items in the cluster configuration file:
mode=online
virtualhost=logical-host-name
onlinehost=active-node-host-name
standbyhost=standby-node-host-name
Save the file as cluster.conf in
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\Base64\
conf.
NOTE:
• For virtualhost, onlinehost, and standbyhost, an IP address cannot be
specified. Also, verify that an IP address can be resolved from the host name.
• The IP address that is assigned to the logical host name specified in virtualhost
must be enabled and accessible.
7. Open the server.properties file and verify that the logical host name is specified in the
server.http.host property.
If the logical host name is not set, change the current value to the logical host name.
installation-folder-of-HP-XP7-Command-View-Advanced-Edition\
DeviceManager\Server\config\server.properties
8. To migrate the data to the shared disk, specify the database on the shared disk as the database
to be used.
The procedure is described in steps 9 through 11.
If a cluster environment has been configured for another HP XP7 Command View Advanced
Edition product, you do not need to do the procedure for migrating the database to the shared
disk and can proceed to step 12.
HP XP7 Command View Advanced Edition server installation in a cluster environment76