HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

7. Select the instances to synchronize and click Refresh Configuration.
When upgrading the Replication Manager server at primary sites, do this for Device Manager
on secondary sites.
When upgrading the Device Manager server at secondary sites, do this for Device Manager on
the upgrade sites.
Resetting the Java Development Kit
When upgrading from version 7.6.1 or earlier and using Oracle Java Development Kit (JDK), the
system defaults to the JDK included with HP XP7 Command View Advanced Edition products. To
change to the Oracle JDK, you need to re-register the JDK.
Prerequisites
Verify that the server meets the minimum requirements and that prerequisite software is installed.
For more information, see HP XP7 Command View Advanced Edition System Requirements.
1. Install the Oracle Java 64-bit JDK for your operating system.
2. Register the JDK that you want to use in the HP XP7 Command View Advanced Edition products.
For details about registering the JDK, see the HP XP7 Command View Advanced Edition
Administrator Guide.
Resetting port numbers
When upgrading from version 7.6.1 or earlier, some port numbers are reset to the default. If the port
numbers were changed using an earlier version of HP XP7 Command View Advanced Edition, reset
the port numbers after the upgrade installation.
Prerequisites
Check the following port numbers to determine if they need to be reset:
• Port numbers used to access HBase 64 Storage Mgmt Web Service.
• Port number for the Start menu URL.
For information about changing port numbers, see the HP XP7 Command View Advanced Edition
Administrator Guide.
Resetting security communication settings
When upgrading from version 7.6.1 or earlier, you need to reset the security communications settings
for HP XP7 Command View Advanced Edition products.
For information about security communications, see the HP XP7 Command View Advanced Edition
Administrator Guide.
Resetting scripts
When upgrading from version 7.6.1 or earlier, command names and file paths are changed.
If you use scripts with written command names and file paths, and will use scripts in version 8.0.0 or
later, review the command names and file paths that are written in these scripts.
HP XP7 Command View Advanced Edition server installation50