HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

2 HP XP7 Command View Advanced Edition
server installation
This module describes how to install and set up servers.
Planning for server installation
Before installing the HP XP7 Command View Advanced Edition (XP7 Command View AE) software
on the server, verify the conditions and gather the information you need to perform the installation.
Server installation conditions
Before using the standard software installer for the XP7 Command View AE server, determine the
required information.
Default values (for example, the installation path and management server information) are provided
by the installation wizard.
NOTE:
HP recommends accepting default values when available.
The items in the table below need to be specified in the installation wizard during installation and
basic setup.
New installations
The following table lists default values that are required for new installations only:
Management server
information
Storage destination path for
database files
Installation destination
path
Platform
Host name set for the
OS or IP address
installation-destination-
path\database
%ProgramFiles%\CVX-
PAE
Windows
/var/installation-destina-
tion-path/database
/opt/CVXPAE
Linux
All installations
The following information is required for all installations:
• Destination for database file backup (if XP7 Command View AE products are already installed
on the management server):
Windows: installation-destination-path\backup
Linux: /var/installation-destination-path/backup
Installation and Configuration Guide 17