HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

B XP7 Command View AE ports
This appendix describes the ports used for HP XP7 Command View Advanced Edition (XP7 Command
View AE). For a complete list of system requirements, see HP XP7 Command View Advanced Edition
System Requirements.
XP7 Command View AE server ports
Ensure that XP7 Command View AE ports do not overlap with those used by other programs on the
management server.
Some ports can overlap with ports temporarily assigned by the operating system. You can prevent
this by defining the ports in the operating system services file.
These ports are described in Table 27.
For more information, see the HP XP7 Command View Advanced Edition Administrator Guide.
Table 27 Port numbers used by XP7 Command View AE
If the port is in use by another productDescriptionPort Number
The settings cannot be changed from Device Manager.
Change the settings for the product that uses this port or follow
the message that is output during installation to disable SNMP
trap reception.
Device Man-
ager ports
162/udp
Change the settings for the product that uses this port or change
Device Manager settings before starting the Device Manager
server.
If another product is using this port, the following message is
output to the event log file and Device Manager does not start:
KAIC00114-E An attempt to start the HTTP server
on port "port-number" failed.
2001/tcp
2443/tcp
Change the settings for the product that uses this port or change
Device Manager settings.
5983/tcp
5988/tcp
5989/tcp
23055/tcp
Change the settings for the product that uses this port or change
Tiered Storage Manager settings.
Tiered Storage
Manager ports
20352/tcp
Change the settings for the product that uses this port or change
Common Component settings.
NOTE: If Common Component is installed and you changed its
ports, you do not need to reset the values.
Common Com-
ponent ports
22015-22018/
tcp
22025/tcp
22026/tcp
22032/tcp
Installation and Configuration Guide 123