HP XP7 Command View Advanced Edition Installation and Configuration Guide (TK981-96001, May 2014)

Default ValueDetailsProperty Name
FALSE
Specify whether to continue
the installation when the host
name or IP address that was
specified in
HINST_IPADDRESS is not
communicating with the
network.
• TRUE: Continue the install-
ation.
• FALSE: Stop the installa-
tion.
HINST_IGNORE_NETWORK-
ING_CHECK
FALSE
Specify whether to continue
the installation when there is
insufficient virtual memory.
• TRUE: Continue the install-
ation.
• FALSE: Stop the installa-
tion.
HINST_IGNORE_VIRTU-
AL_MEMORY_CHECK
Notes:
1. When installing on the active node in a cluster environment, you must specify this property. When installing
on the standby node, you do not need to specify this property.
2. When installing in a cluster environment, you must specify this property on both the active and standby
nodes.
3. If you perform an installation on the standby node in a cluster environment, databases are not backed
up.
4. If you specify this property in a cluster environment, it is ignored.
Related topics
• Server installation path name restrictions (new installations only), page 19
• Database file storage path name restrictions (new installations only), page 20
• Management server information, page 21
• Memory heap size for Device Manager server, page 21
• Database file backup locations, page 22
Prerequisites for XP7 Command View AE server unattended installation
Before performing an unattended installation of XP7 Command View AE server, review system
requirements information.
1. Run Tiered Storage Manager tasks when upgrading from 7.1.0 or earlier:
• If there are incomplete tasks (standby, running, being canceled), go to the Tasks & Alerts tab
and execute or cancel the tasks. After upgrading, register the canceled tasks as new.
2. Check the user group name when upgrading from versions 7.1 to 7.5.0.
• When upgrading to version 7.6.0 or later, private logical groups are created and within
these groups, top folders are created for each user group. The user group name is used as
the initial folder name. Users that have Admin permission for user management should check
the user group name before performing an upgrade installation.
Installation and Configuration Guide 113