HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

mfUniversalReplicatorVolumeType=Unknown
mfUniversalReplicatorPoolID=-1
thpPoolID=-1
threshold=-1
systemDisk=0
encrypted=-1
tieringPolicy=-1
resourcePartitionUnitID=-1
*****: The values are encoded by the CLI.
AddPArrayGroupToPRPU
The AddPArrayGroupToPRPU command registers a parity group that belongs to a physical resource
group to a specific physical resource group. The parity group is registered from a physical resource
group (meta_resource) whose resource group ID is 0.
NOTE:
• You can use this command only when you are using HP XP7.
• Only the parity groups of internal volumes and external volumes can be registered to physical
resource groups.
• All parity groups in a concatenated parity group must belong to the same physical resource group.
If a parity group to be specified is a parity group in a concatenated parity group, specify all the
parity groups that have the same concatenation ID.
• To register the location to which multiple parity groups belong, use the batch function. For details
about the batch function, see Chapter 6 on page 503.
Format
hdvmcli [URL] AddPArrayGroupToPRPU [options]
model=model serialnum=serial-number
rpuid=physical-resource-group-ID
{chassis=chassis-number groupnum=parity-group-number
|arraygroupname=parity-group-name}
Parameters
Table 30 AddPArrayGroupToPRPU command parameters
DescriptionStatusParameter name
Serial number of the storage systemRequired
serialnum
Model of the storage systemRequired
model
Specify the resource group ID of the physical resource group at
the registration destination.
Required
rpuid
Command reference92