HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

DescriptionStatusParameter name
Capacity of the LUs to be created
This parameter must be specified if the creationoption
parameter is not specified, or if bulk or dividebycap is
specified for the creationoption parameter.
This parameter cannot be specified if dividebynum is specified
for the creationoption parameter.
The specified value is adjusted depending on the minimum number
of units set for the volume size of each storage system. Therefore,
the size of the logical unit that was actually created might exceed
the specified value.
You can use the capacitytype parameter to specify the unit
used for capacity (KB or blocks).
Optional
capacity
Number of LUs to be created
This parameter must be specified if bulk or dividebynum is
specified for the creationoption parameter.
Do not specify this parameter if the creationoption parameter
is not specified, or dividebycap is specified for the
creationoption parameter.
Optional
(HP XP7
P9500
XP24000
XP20000
XP12000
XP10000
SVS200)
numoflus
Emulation type of the logical unit
The following are the specifiable emulation types:
• OPEN-3
• OPEN-8
• OPEN-9
• OPEN-E
• OPEN-K
• OPEN-V
Specify the same emulation type as the parity group in which a
logical unit is created.
If no such emulation is present, parity group emulation is used.
This parameter must be specified if the creationoption
parameter is specified. In this case, OPEN-V is the only value you
can specify.
If you specify the creationoption parameter, OPEN-V is the
only value that you can specify for emulation. In addition, if
you specify the creationoption parameter and omit this
parameter, OPEN-V is set.
Optional
emulation
CLI Reference Guide 85