HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

XP12000/
XP10000/
SVS200
XP24000/
XP20000
P9500HP XP7DescriptionValues
--YYY
Set/Report Device Identifier
enable
Specify this value when both of
the following conditions are
satisfied:
• The host mode is set to HP
(mode 03), OpenVMS (mode
05), or Tru64 (mode 07).
• You want to enable the com-
mands that set a nickname for
a device.
33
--YYY
Change the nexus specified in
the SCSI Target Reset
Specify this value when you want
to set either of the following
ranges for each host group when
Target Reset is received:
• Range for resetting jobs
• Range for which UA (Unit At-
tention) is set
39
--YYY
V-Vol expansion
Specify this value when both of
the following conditions are
satisfied:
• The host mode is set to Win-
dows (mode 0C) or Windows
Extension (mode 2C).
• After increasing the THP
volume capacity, you want to
force that capacity to be
automatically recognized.
40
--YYY
Prioritized device recognition
command
Specify this value when you want
to prioritize commands that force
devices to be recognized.
41
--YY--
Prevent "OHUB PCI retry"
Specify this value when you want
to use IBM Z10 Linux.
42
--YYY
Queue Full Response
Specify this value if you want to
force QueueFull to be the reply
to a host when the queue is full.
43
CLI Reference Guide 75