HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

DescriptionStatusParameter name
Serial number of the storage system in the HORCM configuration
file that manages the S-VOL.
To define a copy pair configuration by using a virtual ID, specify
a virtual serial number.
The confsvolserialnum and confsvoldevnum parameters
must be specified at the same time.
Optional
(HP XP7)
confsvolserial-
num
Device number of the storage system in the HORCM configuration
file that manages the S-VOL.
To define a copy pair configuration by using a virtual ID, specify
a virtual device number.
The confsvolserialnum and confsvoldevnum parameters
must be specified at the same time.
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
The execution results are output in decimal.
Optional
(HP XP7)
confsvoldevnum
Type of operation that is to be executed with the copy pair
You can specify the following values:
• BusinessCopy: Business Copy
• ContinuousAccessSync: Continuous Access Synchronous
• ContinuousAccessAsync: Continuous Access Asynchron-
ous
• Snapshot: Snapshot
• ContinuousAccessJournal: Continuous Access Journal
Required
replication-
function
MU number of the P-VOL
This parameter can be specified only for Continuous Access
Journal.
If this parameter is not specified, Device Manager automatically
specifies the value.
Optional
munum
Fence level of the P-VOL
This parameter applies only when Continuous Access Synchronous
is being used. In other cases, the value specified for this parameter
is ignored.
You can specify the following values:
• Never: If you specify Never, a host write request to the P-
VOL will not be rejected even though the MCU was able to
change the status of a S-VOL pair into the suspend status.
• Data: If you specify Data, a host write request to the P-VOL
will be rejected when an update copy fails.
• Status: If you specify Status, a host write request to the
P-VOL will be rejected only when the MCU cannot change
the status of an S-VOL pair to the suspend status.
If you omit the parameter, Never is specified.
Optional
fencelevel
Command reference398