HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

DescriptionStatusParameter name
Specify whether to apply the label information about the
THP/Smart pool to the storage system.
One of the following values can be specified. The values are not
case-sensitive.
• true: Apply the label information to the storage system
• false: Do not apply the label information to the storage
system
If this parameter is omitted, false is assumed to be specified.
Optional
(P9500)
reflectoption
Specify the speed for hardware tier relocation.
This parameter can be specified when tiercontrol is set to
enable.
One of the following values can be specified.
• 1: Slowest
• 2: Slow
• 3: Normal
• 4: Fast
• 5: Fastest
Optional
(HP XP7)
relocation-
speed
#3
#1
If you specify threshold values for overprovisioningwarning and overprovisioninglim-
it, two levels of warnings related to the over-provisioning percent can be issued. For
XP24000/XP20000, these threshold values are specific to and managed by the Device Manager
server.
#2
The over-provisioning percent is the percentage of the total size of all THP/Smart volumes with
respect to the THP/Smart pool size. For example, if the THP pool size is 500 GB and the total
size of all THP volumes is 400 GB, the threshold value is 80 %.
#3
For details about the values used when tiercontrol or automigration setting is changed
from disable to enable, and migrationinterval, monitorstarttime, monitorend-
time, monitoringmode, and relocationspeed are omitted, see “AddPool” on page 99.
#4
There must be an interval of at least one hour between the times specified for monitorstarttime
and monitorendtime. The same time cannot be specified for monitorstarttime and
monitorendtime.
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
poolid
Obtain this value from the execution result of the GetStorageArray (subtarget=Pool)
command. In the execution result of this command, the poolID value appears under An in-
stance of Pool. Use this value to specify the poolid parameter.
adddevnums
CLI Reference Guide 269