HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

DescriptionStatusParameter name
Starting sequence number of virtual LDEVs for which you want to
obtain information
Specify this parameter if you want to obtain virtual information
about some of the virtual LDEVs in a specific storage system.
When virtual LDEVs are ordered by device number from 0 upward,
specify the sequence number of the LDEV from which you want to
start obtaining information.
If you specify this parameter, you must also specify the model,
serialnum, vrpusubinfo, and
numOfVldevElementsFilter parameters. For the
vrpusubinfo parameter, specify VLDEV.
Optional
startVldevEle-
mentNumFilter
Number of virtual LDEVs for which information is to be obtained
Specify this parameter when you want to obtain virtual information
about some of the virtual LDEVs in a specific storage system.
If you specify this parameter, you must also specify the model,
serialnum, vrpusubinfo, and
startVldevElementNumFilter parameters. For the
vrpusubinfo parameter, specify VLDEV.
The maximum recommended value is 4096.
Optional
numOfVldevEle-
mentsFilter
Filter used to select virtual LDEVs for which information is to be
obtained
Specify this parameter if you want to obtain information about
some of the virtual LDEVs in a specific storage system.
The values you can specify are ASSIGNED (exists) or UNASSIGNED
(does not exist).
If you specify this parameter, for the vrpusubinfo parameter,
specify VLDEV.
Optional
vldevfilter
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
vrpuid
Obtain this value from the execution results of the GetStorageArray (subtarget=VResource-
PartitionUnit) command. Execute this command by specifying only the model and serial-
num parameters, and VResourcePartitionUnit for the subtarget parameter. All information
related to VResourcePartitionUnit in the specified storage system can be obtained. In the
execution results of this command, the required resourcePartitionUnitID value appears
under An instance of VResourcePartitionUnit. Use this value to specify the vrpuid
parameter.
Command execution example
In this example, the GetStorageArray (subtarget=VResourcePartitionUnit) command
obtains information about a specific virtual resource group (resource group ID: 1) in a storage system
(serial number: 53038, model: P9500).
CLI Reference Guide 245