HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

GetStorageArray (subtarget=PResourcePartitionUnit)
The GetStorageArray (subtarget=PResourcePartitionUnit) command obtains information
about physical resource groups.
NOTE:
You can use this command only when you are using HP XP7.
Parameters
Table 77 GetStorageArray (subtarget=PResourcePartitionUnit) command parameters
DescriptionStatusParameter name
Specify PResourcePartitionUnit.
Required
subtarget
Serial number of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
serialnum
Model of the storage system
If you omit this parameter, all the storage systems become the
target.
Optional
model
Specify the resource group ID of the physical resource group from
which information is to be obtained.
This parameter must be specified together with the serialnum
and model parameters.
Optional
rpuid
Specify the name of the physical resource group from which
information is to be obtained.
This parameter must be specified together with the serialnum
and modelparameters.
Optional
rpuname
Information about the physical resource group and the virtual
resource group
The values you can specify are PArrayGroup,
PHostStorageDomain, PLDEV, PPort, and
VResourcePartitionUnit. To specify multiple values,
separate them by using commas (,).
Optional
prpusubinfo
Information about the virtual LDEVs that belong to the physical
resource group
The value you can specify is VLDEV. If you specify this parameter,
you must also specify PLDEV for the prpusubinfo parameter.
Optional
pldevsubinfo
Command reference230