HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

DescriptionStatusParameter name
Specify whether to apply the label information about the
THP/Smart pool to the storage system.
One of the following values can be specified. The values
are not case-sensitive.
• true: Apply the label information to the storage system
• false: Do not apply the label information to the storage
system
If this parameter is omitted, it is assumed that false is
specified.
Optional
(P9500)
reflectoption
Specify the speed for hardware tier relocation.
If you specify this parameter, you must also specify
tiercontrol=enable.
One of the following values can be specified.
• 1: Slowest
• 2: Slow
• 3: Normal
• 4: Fast
• 5: Fastest
If this parameter is omitted, 3 is set.
Optional
(HP XP7)
relocationspeed
#1
If you specify threshold values for overprovisioningwarning and overprovisioninglim-
it, two warning levels related to the over-provisioning percent can be issued. For
XP24000/XP20000, these threshold values are specific to and managed by the Device Manager
server.
#2
The over-provisioning percent is the percentage of the total size of all THP/Smart volumes with
respect to the THP/Smart pool size. For example, if the THP pool size is 500 GB and the total
size of all THP volumes is 400 GB, the threshold value is 80 %.
#3
There must be an interval of at least one hour between the times specified for monitorstarttime
and monitorendtime. The same time cannot be specified for monitorstarttime and
monitorendtime.
Parameter values to obtain in advance
serialnum and model
Obtain these values from the execution result of the GetStorageArray command. In the execution
result, use the arrayType value or the displayArrayType value to specify the model para-
meter, and use the serialNumber value to specify the serialnum parameter.
devnums
Obtain this value from the execution result of the GetStorageArray (subtarget=Logic-
alUnit, lusubinfo=LDEV) command. Execute this command by specifying only the model
and serialnum parameters, LogicalUnit for the subtarget parameter, and LDEV for the
lusubinfo parameter. In the execution result of this command, the devNum value of Logic-
alUnit appears under An instance of LogicalUnit. Use the devNum value of a logical
CLI Reference Guide 107