HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

DescriptionStatusParameter name
Over provisioning warning threshold (%)
This is a threshold value related to the over-provisioning
percent.
#2
Specify a threshold value used to issue an advance warning.
For HP XP7 and P9500:
Specify an integer from 0 to 65534. You need to
specify a value smaller than the one specified for
overprovisioninglimit.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to
specify a value smaller than the one specified for
overprovisioninglimit.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
Optional
overprovisioning-
warning
#1
Over provisioning limit threshold (%)
This is a threshold value related to the over-provisioning
percent.
#2
Specify a threshold value used to issue an excess limit
warning.
For HP XP7 and P9500:
Specify an integer from 0 to 65534. You need to
specify a value larger than the one specified for
overprovisioningwarning.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
If you specify a threshold value and the over-provision-
ing percent
#2
exceeds the specified threshold value,
you cannot create a THP/Smart volume.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to
specify a value larger than the one specified for
overprovisioningwarning.
If this parameter is omitted, -1 is set.
-1 indicates that a threshold value is not set.
If you specify a threshold value and the over-provision-
ing percent
#2
exceeds the specified threshold value,
you cannot create a THP volume or assign THP volumes
to a THP pool.
Optional
overprovi-
sioninglimit
#1
Device number of the logical unit(s)
Specify this parameter as a decimal number or
colon-delimited hexadecimal number in the format
ww:xx:yy, where ww is the LDKC number, xx is the CU
number, and yy is the LDEV number. ww is optional. If ww
is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Required
devnums
CLI Reference Guide 103