HP XP P9000 Command View Advanced Edition Suite Software 7.6.1-00 Installation and Configuration Guide

NOTE:
For information about registering port numbers as exceptions, see “Command View AE Suite server
ports” on page 85 .
Related topics
• Command View AE Suite server installation preparations, page 21
• Installing Command View AE Suite on Linux, page 35
Command View AE Suite server installation
When you install Command View AE Suite on the management server, use the installation procedure
that is appropriate for the operating system you are using.
Server installation prerequisites
Before installing Command View AE Suite, review the information in “Planning for server
installation” on page 15. If you are using a Linux management server, a 32-bit library package is
required. You can obtain this package from Red Hat or Novell.
After reviewing the information, perform the following tasks:
Run Tiered Storage Manager tasks when upgrading from 7.1.0 or earlier:
• If there are incomplete tasks (standby, running, or being canceled), go to the Tasks & Alerts tab
and execute or cancel the tasks. After upgrading, register the canceled tasks as new.
Check the user group name when upgrading from versions 7.1 to 7.5.0:
• When upgrading to version 7.6.0 or later, private logical groups are created, and within these
groups, top folders are created for each user group. The user group name is used as the initial
folder name. Users that have Admin permission for user management should check the user group
name before performing an upgrade installation.
• For details about private logical groups, see the HP P9000 Command View Advanced Edition
Suite Software User Guide.
Determine values that are set during installation:
• The installation destination path
• The database storage destination path
• Management server information
• Memory heap size
• The database backup destination
Prerequisite checker
The prerequisite checker verifies whether the installation destination satisfies the requirements.
• In Windows, use the integrated installation media or run the prereqchk.exe file in DVD-drive:\
HCS\
• In Linux, run the prereqchk.sh file in DVD-ROM-mount-point/HCS/platform-name/
Installation and Configuration Guide 33