HP XP P9000 Command View Advanced Edition Suite Software 7.6.0-00 CLI Reference Guide

DescriptionStatusParameter name
Capacity of THP/Smart volumes
You can use the capacitytype parameter to specify the unit
used for capacity (KB or blocks).
You can specify the following values:
For P9500:
- 48000 to 64424505600 (in KB)
- 96000 to 128849011200 (in blocks)
For XP24000/XP20000:
If the microcode version is earlier than 60-03:
- 48000 to 3221159680 (in KB)
- 96000 to 6442319360 (in blocks)
If the microcode version is 60-03 or later:
- 48000 to 4294967296 (in KB)
- 96000 to 8589934592 (in blocks)
Required
capacity
Number of THP/Smart volumes
Specify the number of THP/Smart volumes to be created.
If this parameter is omitted, 1 is set.
Optional
numoflus
Device number of the logical unit
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
If this parameter is omitted, it is set automatically.
Optional
devnum
CLPR number
If this parameter is omitted, 0 is set.
For XP24000/XP20000, if the poolid parameter has been
specified, the CLPR number of the THP pool identified by the pool
ID is set.
Optional
(XP24000
XP20000)
clprNumber
Pool ID of a THP/Smart pool
Specify the pool ID of the THP/Smart pool to which to assign the
THP/Smart volumes to be created.
For P9500, always specify this poolid parameter.
Optional
poolid
Usage rate threshold for the THP volumes (%)
Specify a multiple of 5 from 5 to 300.
If omitted, 5 is set.
If the poolid parameter is omitted, the specification for this
parameter becomes invalid.
Optional
(XP24000
XP20000)
threshold
Unit of the value specified in the capacity parameter.
You can specify either KB or block.
If this parameter is omitted, KB is set.
Optional
capacitytype
CLI Reference Guide 99