HP XP P9000 Command View Advanced Edition Suite Software 7.6.0-00 CLI Reference Guide

Pool instance
Commands for which a Pool instance is output
• AddPool, page 78
• AddTieredPoolOperation, page 93
• GetPoolShrinkStatus, page 127
• GetStorageArray (subtarget=Pool) , page 178
• GetTieredPoolStatus, page 200
• ModifyExternalTierRank, page 204
• ModifyPool, page 211
• ShrinkPool, page 248
NOTE:
The attributes thresholdVolForewarn and thresholdVolOverwarn, which were supported
in version 6.2, have changed to overProvisioningWarning and overProvisioningLimit,
respectively. Check and, if necessary, revise the script that you use in version 6.3 or later.
Table 143 Pool instance attributes
DescriptionAttribute
Object ID of the Pool instanceobjectID
Name of the pool
This is output if the name has been registered.
name
Outputs the function by which the pools are being used.
• 3: Snapshot
• 4: Continuous Access Journal Software
• 5: Thin Provisioning
• 6: Fast Snap
poolFunction
ID of the Pool
The ID is output for the pool that corresponds to the function type output to
poolFunction.
poolID
Currently, this information does not apply to storage systems (-1 is output).encrypted
Logical DKC number
The value output depends on the storage system and poolFunction values.
For P9500 and XP24000/XP20000
When poolFunction is 4: Logical DKC number
-1 is output for other cases.
-1 is output for other storage systems.
controllerID
CLI Reference Guide 383