HP XP P9000 Command View Advanced Edition Suite Software 7.6.0-00 CLI Reference Guide

DescriptionAttribute
Pool ID of logical unit
One of the following values is output for P9500, XP24000/XP20000, or
XP12000/XP10000/SVS200:
• When the logical unit is the P-VOL, S-VOL,or SP-VOL of Continuous Access
Journal Software: Pool ID of the pool used by the logical unit
• When the logical unit is a pool volume: Pool ID of the pool to which the logical
unit has been assigned
In other cases, -1 is output.
journalPoolID
Type of the Thin Provisioning volume
One of the following values is output for P9500 or XP24000/XP20000:
• -1: Non-THP/Smart volume
• 0: THP/Smart volume
• 1: THP/Smart pool volume
-1 is output for other storage systems.
thpType
Usage of on the THP/Smart volume (KB)
One of the following values is output for P9500 or XP24000/XP20000:
• When the logical unit does not consist of THP/Smart volumes: The same value
as capacityInKB.
• When the logical unit consists of THP/Smart volumes: Usage of on the
THP/Smart volumes.
-1 is output for other storage systems.
For P9500 or XP24000/XP20000, note the following points on the value that is
output for THP/Smart volume usage:
• When the THP/Smart volumes are not assigned to a THP/Smart pool, 0 is
displayed.
• When the operator is a partitioned storage manager, -1 is output.
• Volume capacity is allocated from the logical unit in units of tens of megabytes,
so, when the usage rate of the logical unit reaches 100%, the value of con-
sumedCapacityInKB might not match the value of capacityInKB.
• This value might increase significantly depending on the combination of the
file system and the OS of the host that is using the THP/Smart volumes. For
details, see the Thin Provisioning documentation.
consumedCapa-
cityInKB
Pool ID of the Thin Provisioning
One of the following values is output for P9500 or XP24000/XP20000:
• When the logical unit consists of THP/Smart volumes: Pool ID of the THP/Smart
pool to which the THP/Smart volumes are assigned.
#1, #2
• When the logical unit consists of THP/Smart pool volumes: Pool ID of the
THP/Smart pool that contains the THP/Smart pool volumes.
#2
• For other volumes : -1 is output.
#1
When the THP/Smart volumes are not assigned to a THP/Smart pool, -1 is
displayed.
#2
When the operator is a partitioned storage administrator, -1 is displayed.
-1 is output for other storage systems.
thpPoolID
CLI Reference Guide 375