HP XP P9000 Command View Advanced Edition Suite Software 7.6.0-00 CLI Reference Guide

DescriptionStatusParameter name
Specify whether to automatically execute performance monitoring
and hardware tier relocation.
If you specify this parameter, you must also specify
tiercontrol=enable.
This parameter can be specified when tiercontrol is set to
enable.
One of the following values can be specified.
• enable: Performs automatic execution.
• disable: Does not perform automatic execution.
Optional
(P9500)
automigra-
tion
#1, #5
Execution cycle of performance monitoring and hardware tier
relocation
This parameter can be specified when automigration is set
to enable.
One of the following values can be specified.
• 0: 30 minutes
• 1: 1 hour
• 2: 2 hours
• 4: 4 hours
• 8: 8 hours
• 24: 24 hours
You can specify 0 only when the microcode version is
70-02-XX-XX/XX or later.
Optional
(P9500)
migrationinter-
val
#1, #5
Start time of performance monitoring
This parameter can be specified when migrationinterval
is set to 24.
Specify a time in the range from 00:00 to 23:59 in HH:MM
format.
Optional
(P9500)
monitorstart-
time
#1, #5, #6
End time of performance monitoring
This parameter can be specified when migrationinterval
is set to 24.
Specify a time in the range from 00:00 to 23:59 in HH:MM
format.
Optional
(P9500)
monitorend-
time
#1, #5, #6
Performance monitoring mode.
This parameter can be specified when tiercontrol is set to
enable.
Specifiable values vary, depending on the microcode version.
If the microcode version is earlier than 70-02-XX-XX/XX:
0: Periodic
If the microcode version is 70-02-XX-XX/XX or later:
0: Periodic
1: Continuous
Optional
(P9500)
monitoring-
mode
#1, #5
CLI Reference Guide 215