HP StorageWorks P9000 Tiered Storage Manager Software 7.1 CLI Reference Guide (TB585-96011, May 2011)

subsystemName=XP24000@10.208.115.221
notifyToURL=mailto:[e-mail]
description=This property was changed.
List of 1 ExternalMappingInfo elements:
An instance of ExternalMappingInfo(1 of 1)
externalDeviceNumber=0:28
externalDeviceID=-
Are you sure you want to delete this task? (Y/N) :
Commands for obtaining information from the domain controller
This section explains the CLI commands for obtaining information from a domain controller.
GetVolumes
The GetVolumes command can be used to obtain a list of volumes (LUs) in the domain controller
within the storage domain.
You can specify a storage tier name or migration group name to limit the number of items in the list
of volumes. You can further limit the items obtained by specifying the combination of a storage tier
or migration group with a volume filter condition.
Information cannot be obtained for volumes in storage domains whose refresh status is either
Processing or Failure.
If this command is executed for a storage domain that requires a refresh, a warning message will be
output to the standard error output.
NOTE:
Note the following points when viewing the items output by the GetVolumes command:
• If information about a volume in the storage domain cannot be obtained because the volume in
the storage system has been deleted using Device Manager, Unknown will be output as the value
of the output items.
• The GetVolumes command acquires volume information in pieces, and then displays the acquired
information. This means that if another user performs an operation on a volume, changing the
volumes state, during the execution of the GetVolumes command, the information that is displayed
might contain both data acquired before and after the change was made.
Syntax
htsmcli [ server-location] GetVolumes
[ common-option ]
[ { -d | --detail } ]
storagedomainname=storage-domain-name
[ { storagetiername=storage-tier-name
| migrationgroupname=migration-group-name } ]
[ filtercondition=filter-condition ]
CLI Reference Guide 185