HP StorageWorks P9000 Tiered Storage Manager Software 7.1 CLI Reference Guide (TB585-96011, May 2011)

DetailsParameter
Specify whether the data for the migration source volume is to be deleted once
after migration terminates normally. This can be either Yes or No:
• Yes: Delete the data
• No: Do not delete the data
The default value differs depending on the value of the
server.migration.dataErase.defaultValue key in the
server.properties file, and the value of parameter.erasedata in the
htsmcli.properties file. The settings in the htsmcli.properties file takes
precedence over the settings in the server.properties file.
[erasedata]
Specify whether the unused capacity in the migration target volume is to be released
after migration terminates normally.
• Yes: Release the unused capacity. (Default)
• No: Do not release the unused capacity.
To enable this parameter specification, the following conditions must be satisfied:
• The migration target volume is either a THP volume or THP pool.
• The migration source volume is not a volume that is part of a Business Copy or
Snapshot pair.
• If the storage product is XP24000/XP20000, the microcode version is 60-07-
0x-xx/xx or later.
If the above conditions are not satisfied, even if Yes is specified for this parameter,
the unused capacity is not released, and no message will be output.
[zerodatadiscard]
Specify the address to be notified when the event occurs.
Specify a value by combining mailto: and the email address.
[notifytourl]
Specify a description of the migration task.
[description]
Legend:
[ ]: Specifying this parameter is optional.
Output items
Table 46 Items output by the CreateMigrationTask command (Task instance)
DescriptionItem
The task ID.
The task ID format is TK########. The time and serial number are converted to
base 36 and displayed in the format ########.
ID
The type of task (Migration)taskType
The task status
For details on the values displayed, see “Task statuses” on page 207.
status
The estimated time for the task execution. If you specify the erasedata parameter
during task creation, and then execute the task, this value will include the time to
delete data.
This value is displayed in hhhh:mm:ss format.
If the estimated value is 10,000 hours or more, 9999:59:59 is displayed.
timeEstimate
CLI Reference Guide 121