HP StorageWorks P9000 Replication Manager Software 7.1 CLI Reference Guide (TB584-96021, May 2011)

DescriptionDisplayed item
The partition style of the physical volume displayed on the DEVICE.
(One of MBR, GPT, RAW, or ---)
When UNKNOWN is displayed for DEVICE, --- is displayed.
TYPE
The current disk signature (in hexadecimal) of the physical volume
displayed for DEVICE.
When UNKNOWN is displayed for DEVICE, -------- is displayed.
CUR_DISKID
The disk signature recorded in the backup catalog (in hexadecimal).
When the disk signature is not set (for example, because backup was
performed in an environment of Protection Manager version 4.1 or
earlier), or when the backup ID is not specified, -------- is displayed.
BKU_DISKID
-sigset disk-signature
Updates the disk signature of the physical volume. Use this option to restore operation when the
KAVX5137-E message is output and the restoration command terminates with an error.
When you specify the -sigset option, you must specify either the backup ID or the -copy_group
copy-group-name at the same time.
• When the -sigset option and backup-ID are specified at the same time, the current disk sig-
nature is updated in accordance with the disk signature that was recorded at the time of backup.
You cannot specify an arbitrary disk signature.
• When the -sigset option and the -copy_group copy-group-name are specified at the
same time, the current disk signature is updated in accordance with the specified disk signature
that follows the -sigset option. In this case, a disk signature must always be specified.
The disk signature to be specified differs depending on the partition style.
The following table lists partition styles and corresponding disk signatures to be specified.
Table 33 Partition styles and corresponding disk signatures to be specified
RemarksFormat (Example)Partition style
Hexadecimal, maximum
8 digits
ABCDEF01
MBR
GUID
(Curly brackets ({}) are
not used.)
ABCDEF01-2345-6789-ABCD-EF0123456789
GPT
Notes
• A backup ID and the -copy_group option cannot be specified at the same time.
• If neither the backup-ID option nor the -copy_group option is specified, the secondary volumes
of all copy groups managed by Application Agent will be targeted.
The RAID Manager instance used by Application Agent is specified in the RAID Manager-linkage
definition file (DEFAULT.dat) as HORCMINST=n. Of the two volumes defined as pair volumes in
a RAID Manager instance, the volume directly managed by the RAID Manager instance used by
Application Agent is the secondary volume.
Basic commands116