HP StorageWorks P9000 Command View Advanced Edition Suite Software 7.1.1 CLI Reference Guide (TB581-96066, September 2011)

DescriptionStatusParameter name
Port number of the new path
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
port
Port name of the new path
Specify either port or portname. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
portname
Domain ID of the new path
You cannot specify this parameter and the domainnickname
parameter at the same time. If they are specified at the same time,
an error will occur.
This parameter can be specified in decimal and hexadecimal. If
you specify a hexadecimal number, add the 0x prefix.
The execution results are output in decimal.
Optional
domain
Nickname of the host storage domain of the new path
You cannot specify this parameter and the domain parameter at
the same time. If they are specified at the same time, an error will
occur.
Optional
domainnickname
SCSI ID of the new path
For Fibre Channel, specify 15.
Optional
scsi
Actual LUN used for new pathRequired
lun
Device number used to identify the new path (not provided when
a LUSE is defined)
This parameter can be specified in decimal, and in
colon-separated hexadecimal. If you specify a hexadecimal
number, for XP12000/XP10000/SVS200 or XP1024/XP128,
use the xx:yy format, where xx is the CU number, and yy is
the LDEV number. For P9500 or XP24000/XP20000, use the
ww:xx:yy format, where ww is the LDKC number, xx is the CU
number, and yy is the LDEV number. ww is optional. If you omit
ww, the LDKC number is regarded as 0.
The execution results are output in decimal.
Specify either devnum or lusedevnums. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
devnum
Comma-separated list of LDEV numbers to create a LUSE for the
path
The format you can use when specifying and the format of the
execution results are the same as devnum.
Specify either devnum or lusedevnums. Do not specify both
parameters at the same time. If they are specified at the same
time, an error will occur.
Optional
lusedevnums
#
#
Command reference202