HP StorageWorks P9000 Command View Advanced Edition Software Common Component Security Guide

Creating a system
20
4 Creating a system
When the preparations required for system operation are complete, create the system. This chapter
describes how to create a system in the configuration evaluated based on Common Criteria for
Common Component.
• Overview of system creation (see section 4-1 )
• Installation (see section 4-2 )
• Setting up an environment (see section 4-3 )
• Settings required after installation of HP StorageWorks P9000 Command View Advanced
Edition Software Common Component (see section 4-4 )
• Setting up the HP StorageWorks P9000 Command View Advanced Edition Software Common
Component management functions (see section 4-5 )
• Setting up user authentication information (see section 4-6 )
• Setting up external authentication servers (see section 4-7 )
4-1 Overview of system creation
4-1-1 System creation procedure
The following figure shows the procedure for creating a system.
Figure 4-1 Procedure for Creating a System
4-2 Installation
This section describes how to install Common Component.
Common Component is installed when the HP StorageWorks P9000 Command View Advanced
Edition Suite software is installed. To install the management software selected as described in
section 3-1 based on subsection 1-3-3 , the system integrator must perform the applicable
procedure described in the following sections according to the type of operating system.