HP StorageWorks Command View XP Advanced Edition Device Manager Agent Installation and Configuration Guide (December 2005)

Installation Requirements and Procedures 13
2-3 Acquiring WWN Information without Host Recognizing
Logical Units
To acquire WWN information for an HBA, in the situation when the host running the Device Manager
agent recognizes no logical unit of the storage subsystem, you must have the HBA models and the
HBA API library provided by the HBA vendors shown in
Table 2-2.
Table 2-2 Required HBA Models when no Storage Subsystem Connected
OS Model Name Comment
Emulex LP8000
Emulex LP9002DC
Emulex LP9002L
Emulex LP9802
Windows
®
QLogic QLA23xx See Note
JNI FCI-1063
JNI FC64-1063
JNI FCE-6410
JNI FCE-6460
Solaris™
QLogic QLA2200
IBM6227 AIX
®
IBM6228
HP A3404A
HP A3591B
HP A3636A
HP A3740A
HP A5158A
HP A6684A
HP A6685A
HP-UX
HP A6795A
Linux
®
QLogic QLA2200F
NOTE: If the Fibre Channel Information Tool is downloaded from the Microsoft
®
web site and then installed,
the QLogic HBAs can be used.
2-4 Requirements for Using FC-HUB (FC-SWITCH)
Before you connect a host with disk arrays via FC-HUB (or FC-SWITCH), use the following procedure
to confirm whether FC-HUB (or FC-SWITCH) and its firmware are available for the disk array:
• Check the supported HBA (see section
2-3 , for information relating to each type of target disk
array).
• Check the FC-HUB and related firmware supported by the target disk arrays.
Please refer to the appropriate documentation for your disk array.