HP P9000 Replication Manager Software 7.3.1-00 Configuration Guide

logger.MaxBackupIndex * logger.MaxFileSize

For details about the logger.properties file, see “logger.properties” on page 88.

NOTE:

The configuration must always be refreshed when Replication Monitor is upgraded from v5.x to v7.x

Resource Limits

The maximum number of resources that can be managed by Replication Manager depends on the

memory heap size (Small, Medium, or Large). Set an appropriate memory heap size, depending on

the maximum number for each resource.

NOTE:

If you are using a Windows 32-bit environment, you cannot set “Large” as a memory heap size.

For details about how to increase the memory heap size, see the HP P9000 Command View Advanced

Edition Suite Software Installation and Configuration Guide.

This section discusses the following:

• Maximum number of copy pairs, page 35

• Maximum number of LDEVs, page 36

• Log data and number of copy pairs, page 37

Maximum number of copy pairs

The following table shows the maximum number of copy pairs.

Table 13 Maximum number of copy pairs that can be managed

Number of copy pairs

by memory heap size

Environment

LargeMediumSmall

24,00012,0006,000Open systems only

90,00060,00040,000Mainframe systems only

90,00060,00040,000

Combined open and mainframe

Notes:

1. Use this formula to determine the number of copy pairs:

(number-of-copy-pairs-for-open-systems * 6) + number-of-copy-pairs-for-

mainframe-systems

Configuration Guide 35