HP P9000 Replication Manager Software 7.3.1-00 Application Agent CLI Reference Guide

-ef Exchange-environment-setting-file-name
Specify this option to change the parameter used for linking with Exchange Server each time a
command is executed.
For Exchange-environment-setting-file-name, specify a file name only. Do not specify a
folder name.
The specified Exchange environment settings file must be stored in the following folder:
Application-Agent-installation-folder\conf\exchange
If this option is omitted, the default value is used.
For details about the Exchange environment settings file, see the HP P9000 Replication Manager
Software Application Agent CLI User Guide.
Notes
• The backup information in the backup catalog is managed based on using the copy group as a
key. Depending on the backup method, you might not be able to perform restoration, even though
the backup data exists on the secondary volume. For further information, see the notes on running
Application Agent in the HP P9000 Replication Manager Software Application Agent CLI User
Guide.
Note the following when restoring backup data obtained using VSS in units of Information Stores
when using Exchange Server 2003 or Exchange Server 2007:
• When restoring backup data in units of Information Stores, if you specify both an Information Store
name and a storage group name, operations will occur as described below:
• If you specify a storage group name and an Information Store name of the same storage group,
an error will occur.
• If you specify a storage group name and an Information Store name of different storage groups,
the backup data is restored in units of storage groups and Information Stores respectively.
• If you specify an Information Store name of data other than backup data obtained using VSS, an
error will occur.
• If you omit an Information Store name and specify storage-group-name\, an error will occur.
• When you want to specify an Information Store name, check the value displayed in INFORMA-
TIONSTORE of the drmexgcat command and specify exactly the same Information Store name.
• At restoration, this command dismounts all Information Stores within the storage group to which
the specified Information Store belongs.
• If the restoration target disk contains Information Store files that are not restoration targets, an error
will occur.
• If the restoration target disk contains data from different storage groups, an error will occur.
Return Values
0: Normal termination
Any value other than 0: Termination with an error
Examples
• In this example, the command is used to restore, by disk resynchronization, the backup data
identified by the backup ID 0000000001:
Application Agent CLI Reference Guide 211