HP P9000 Replication Manager Software 7.3.1-00 Application Agent CLI Reference Guide

Arguments
backup-ID
Specify the backup ID of a backup catalog. When a backup ID is specified, the target physical volumes
are the secondary volumes of the copy groups registered in the backup catalog.
-copy_group copy-group-name
Specify a valid copy group name. The target physical volumes are the secondary volumes of the copy
group specified.
-detach
Conceals the physical volumes of the storage system from the server, and instructs the OS of the server
to perform a disk rescan.
-attach
Reveals (publishes) physical volumes of the storage system that are concealed from the server, and
instructs the OS of the server to perform a disk rescan.
-noscan
Specify this to stop the OS from being instructed to perform a disk rescan, after a volume is concealed
or revealed. Note that if even one volume is concealed or revealed, an OS disk rescan instruction
(-rescan) is necessary. Because an inconsistency might develop between the OS and the actual
disk configuration if no disk rescan instruction is performed, operation is not guaranteed if operations
other than drmdevctl -detach or drmdevctl -attach are executed.
This option must be specified when either the -detach or -attach option is specified.
-rescan
Instructs the OS to perform a disk rescan. A disk rescan is required after a volume is concealed or
revealed. The time required to process a disk rescan depends on the hardware configuration, and
particularly on the number of connected disks.
This option cannot be specified with other options.
-sigview
Displays the disk signatures of the physical volumes. Use this option to restore operation when the
KAVX5137-E message is output and the restoration command terminates with an error.
• When a backup ID is specified with the -sigview option:
The disk signature recorded when the backup was made is displayed. You can use this to compare
the value of the current disk signature with the value at the time the backup was created.
• When both the -sigview option and -copy_group copy-group-name are specified at the
same time, or neither the backup ID for the -sigview option nor the -copy_group copy-
group-name is specified, only the current disk signature is displayed. The disk signature registered
at backup is displayed as --------.
Application Agent CLI Reference Guide 115