HP P9000 Replication Manager Software 7.2 Configuration Guide

ValueType
28,000,000jsp
47,290,000Total
100Virtual memory
Disk space for Replication Monitor log files (5.x upgrade only)
To determine the space required for backing up the Replication Monitor log file, use the following
formula (which uses the settings in the logger.properties file)
logger.MaxBackupIndex * logger.MaxFileSize
For details about the logger.properties file, see “logger.properties” on page 83.
NOTE:
The configuration must always be refreshed when Replication Monitor is upgraded from v5.x to v7.x
Resource Limits
The maximum number of resources that can be managed by Replication Manager depends on the
memory heap size (Small, Medium, or Large). Set an appropriate memory heap size, depending on
the maximum number for each resource.
NOTE:
If you are using a Windows 32-bit environment, you cannot set “Large” as a memory heap size.
For details about how to increase the memory heap size, see the HP P9000 Command View Advanced
Edition Suite Software Installation and Configuration Guide.
This section discusses the following:
• Maximum number of copy pairs, page 32
• Heap size in a mixed environment, page 33
• Number of copy pairs on open systems, page 34
• Log data and number of copy pairs, page 34
• Maximum number of LDEVs, page 33
Maximum number of copy pairs
The following table shows the maximum number of copy pairs.
Table 13 Maximum number of copy pairs that can be managed
Memory heap size
Environment
LargeMediumSmall
24,00012,0006,000Open systems
Replication Manager system configurations and requirements32