HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

DescriptionStatusParameter name
Names of the source hosts
To specify multiple host names, separate them by commas.
Commas contained in the host name are recognized as delimiters.
Therefore, if the host name contains a comma, use the
ModifyHost command to change the host name so that it does
not contain a comma before executing the MergeHost command.
You can migrate a maximum of 100 WWNs at one time. Specify
source hosts so that the total number of WWNs assigned to those
hosts does not exceed 100.
Do not specify a host to which a WWN is not registered. If you
do so, an error will occur.
Required
hostnames
Parameter values to obtain in advance
targetname and hostnames
Obtain this value from the execution result of the GetHost command. In the execution result of
this command, the name value appears under An instance of Host. Use this name value
to specify the targetname or hostnames parameter.
Command execution example
hdvmcli MergeHost -o "D:\logs\MergeHost.log"
"targetname=host0" "hostnames=host6,host7"
Command execution result
RESPONSE:
An instance of Host
objectID=*****
name=host0
hostID=1
capacityInKB=0
hostType=-1
statusOfDBUpdating=0
List of 2 WWN elements:
An instance of WWN
WWN=50.06.0E.80.05.27.35.47
An instance of WWN
WWN=10.00.00.00.C9.3D.2A.88
*****: The value is encoded by the CLI.
ModifyHost
ModifyHost modifies information about a host server.
CLI Reference Guide 273