HP P9000 Command View Advanced Edition Suite Software 7.4.0-00 CLI Reference Guide (TB581-96326, December 2012)

externalMixCompatible=disable
monitoringState=1
lastMonitorStartDate=2011/07/14 07:48:00
lastMonitorEndDate=-1
relocationState=0
relocationProgress=-1
numberOfTiers=1
thresholdRepDepAlert=-1
thresholdRepDataReleased=-1
userUsedCapacityInKB=-1
repDataCapacityInKB=-1
repManageCapacityInKB=-1
numberOfThpVols=-1
capacityOfThpVolsInKB=-1
*****: The value is encoded by the CLI.
GetZeroPageReclaimStatus
GetZeroPageReclaimStatus obtains the execution status of a zero-page reclaim operation
executed on THP/Smart volumes by the RunZeroPageReclaim command.
If LogicalUnit instances are displayed in the execution result of the GetZeroPageReclaimStatus
command, the zero-page reclaim operation is in progress. When the operation finishes, the
LogicalUnit instances are no longer displayed. Note, however, that no LogicalUnit instances
will be displayed if a zero-page reclaim operation has not been executed by the
RunZeroPageReclaim command.
NOTE:
This command can be used only with P9500 and XP24000/XP20000. The microcode version required
for XP24000/XP20000 is 60-07-00-XX/XX or later.
Parameters
Table 65 GetZeroPageReclaimStatus Command Parameters
DescriptionStatusParameter Name
Serial number of the storage systemRequired
serialnum
Model of the storage systemRequired
model
Device number(s) of THP/Smart volume(s)
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Required
devnums
Parameter values to obtain in advance
None.
Command reference184