HP P9000 Command View Advanced Edition Suite Software 7.3.1-00 CLI Reference Guide

Pool instance
The Pool instance is output when the following commands are executed:
• AddPool, page 71
• AddTieredPoolOperation, page 85
• GetPoolShrinkStatus, page 113
• GetStorageArray (subtarget=Pool) , page 164
• GetTieredPoolStatus, page 179
• ModifyExternalTierRank, page 184
• ModifyPool, page 190
• ShrinkPool, page 219
NOTE:
The attributes thresholdVolForewarn and thresholdVolOverwarn, which were supported
in version 6.2, have changed to overProvisioningWarning and overProvisioningLimit,
respectively. Check and, if necessary, revise the script that you use in version 6.3 or later.
Table 136 Pool instance attributes
DescriptionAttribute
Object ID of the Pool instanceobjectID
Name of the pool
This is output if the name has been registered.
name
Outputs the function by which the pools are being used.
• 3: Snapshot
• 4: Continuous Access Journal Software
• 5: Thin Provisioning
poolFunction
ID of the Pool
The ID is output for the pool that corresponds to the function type output to
poolFunction.
poolID
ID of the disk controller
Valid for P9500 and XP24000/XP20000.
When poolFunction is 3: ID of the controller to which the pool belongs
When poolFunction is 4: Logical DKC number
-1 is output for other cases.
-1 is output for other storage systems.
controllerID
CLI Reference Guide 347