HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
Continuous Access with the HyperSwap attribute cannot be used in
this storage system because 2DC configuration with HyperSwap and
Continuous Access Journal is not supported. Use a device
#
in which
2DC configuration with HyperSwap and Continuous Access Journal
can be used. Also, if scanning was not performed after the storage
system microcode was updated, perform a scan.
SUPFnc (hexadecimal number)
Value for the version (minimum value) of the storage system support
function used in the copy group
#: The storage systems for which 2DC configurations with HyperSwap
and Continuous Access Journal can be used are XP24000s with a
storage system support function version of X'22' or later.
This copygroup does not support
LinkageOption=HS. SUPFNC=SUP-
Fnc
YKH205W TSO
Nothing or an invalid value is assigned to the parameter identified by
name.
name
Parameter name
Unable to execute without valid
name parameter.
YKJ000E TSO RC=48
The parameter identified by name is too long.
name
Parameter name
name parameter is too long.
YKJ001E TSO RC=48
The specified prefix is being used by another program.
Check the value specified for the prefix.
The specified PREFIX is being used
by another program.
YKJ002E TSO RC=48
An error occurred during execution of the YKIMPORT command or
YKEXPORT command.
See the error message message-text and resolve the problem. Also
see the additional information indicated by message-value and
message-severity and take appropriate action.
If the acquisition of information denoted by message-text,
message-value, or message-severity fails, FATAL is displayed
instead of the information that should be acquired. The reasons for
FATAL to be displayed include an insufficient region size. Review the
current region size, and then retry executing the command.
If the problem is not resolved, contact Technical Support for assistance.
info
Maintenance information
message-text
Error message
message-value
Additional information about the error message
If no additional information is available, a space is displayed.
message-severity
Additional information about the error message
If no additional information is available, a space is displayed.
The error messages message-text, message-value, and
message-severity are displayed on the TSO/E terminal. Depending
on the length of the error messages, they might extend over several
lines.
Error occurred during execution.
Cmd= info
msg= message-text:
message-value:
message-severity
YKJ051E TSO RC=32
Messages94