HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)
Table Of Contents

Explanation and recommended actionsMessage textMessage ID
No copy pairs were detected within the specified range.
Check the operating range and status of the copy pair that you want
to acquire, and execute the YKH2B command again. If the copy pair
status is SIMPLEX, the YKH2B command will not detect the copy pair.
In addition, if you execute the YKH2B command without specifying the
HS parameter or execute the YKH2B by specifying HS(CHECK) while
HyperSwap is disabled, copy pairs cannot be detected.
No copy pair was discovered.YKH002I TSO
Check the following, and then re-execute the command:
• Make sure that the required parameter indicated by parameter-
name was specified.
• Make sure that the value specified for the required parameter in-
dicated by parameter-name is valid.
parameter-name
Name of the invalid or missing parameter
Missing or invalid parameter:
parameter-name
YKH100E TSO
The specified prefix is being used by another program.
Check the value specified for the prefix.
The specified PREFIX is being used
by another program.
YKH101E TSO
An error occurred during execution of the YKH2B command.
See the explanation corresponding to the message ID of the error
message indicated by message-text and take appropriate action.
Also see the additional information indicated by message-value
and message-severity and take appropriate action. If the problem
is not resolved, contact your HP Technical Support or authorized service
provider.
info
Maintenance information
message-text
Error message
message-value
Additional information about the error message
If no additional information is available, a space is displayed.
message-severity
Additional information about the error message
If no additional information is available, a space is displayed.
The error messages message-text, message-value, and
message-severity are displayed on the TSO/E terminal. Depending
on the length of the error messages, they might extend over several
lines.
Error occurred during execution.
Cmd=info
msg=message-text:
message-value:
message-severity
YKH102E TSO
No copy pair information was acquired from the volume with the device
number indicated by Devn. There might not be a volume for the
specified device number.
If a volume does exist for the specified device number, check the
channel settings.
Devn
Device number assigned to the volume from which no copy pair
information was acquired
No information was acquired for
DEVN=Devn
YKH200W TSO
Messages92