HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
The XML element identified by name2 contained the XML element
name1 that cannot be specified.
Correct the specification on the line with the line number identified by
rec# in the file identified by file.
file
Name of the configuration file where the error was detected
rec#
Number of the line in the file identified by file where the error
was detected
The element name1 is not a content
of the element name2.
YKG276E MSG
SC=36 RC=36
(file:rec#)
The XML element name is missing.
Correct the specification on the line with the line number identified by
rec# in the file identified by file.
file
Name of the configuration file where the error was detected
rec#
Number of the line in the file identified by file where the error
was detected
name element missing.
YKG277E MSG
SC=36 RC=36
(file:rec#)
The disk device element's SerialNum must be the same as the
SerialNum value (HDASN) of the disk configuration element, but DDSN
is defined for this value.
Correct the specification on the line with the line number identified by
rec# in the file identified by file.
file
Name of the configuration file where the error was detected
rec#
Number of the line in the file identified by file where the error
was detected
Serial Number HDASN is required,
but Serial Number DDSN is found.
YKG285E MSG
SC=36 RC=36
(file:rec#)
A device address domain ID created by a Remote Scan or NG Scan
is specified.
Specify the local device address domain ID of the primary site in the
DAD parameter. For details about the NG Scan, see the HP XP7 for
Business Continuity Manager Software User Guide.
file
Name of the configuration file where the error was detected
rec#
Number of the line where the error was detected in the file identi-
fied by file
Specify the local DADID of the
primary site for the DAD() parameter.
YKG286E MSG
SC=36 RC=36
(file:rec#)
An attempt to acquire the variable vn failed with the result value
identified by result. This error can be caused by an invalid value
being specified for the STEM parameter.
YKVGET program failure for: vn
YKG290E MSG
SC=44 RC=44 (res-
ult)
Messages90