HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
A P-VOL not defined in the disk configuration definition file was included
among the PPRC copy pairs detected by the YKP2B command.
Check whether this P-VOL is defined in the disk configuration definition
file.
CopyType
The copy type of the detected undefined volume
Devn
The device number of the detected undefined volume
SerialNum
The serial number of storage system of the detected undefined
volume
CU#
The control unit number of the detected undefined volume
CCA#
The command control address number of the detected undefined
volume
Unable to resolve primary volume
information. Pair=Copy-
Type,DEVN=Devn,SN=Serial-
Num,CU=CU#,CCA=CCA#
YKB202W TSO
An S-VOL not defined in the disk configuration definition file was
included among the PPRC copy pairs detected by the YKP2B command.
Check whether this S-VOL is defined in the disk configuration definition
file.
CopyType
The copy type of the detected undefined volume
SerialNum
The storage system serial number of the detected undefined volume
CU#
The control unit number of the detected undefined volume
CCA#
The command control address number of the detected undefined
volume
Unable to resolve secondary volume
information. Pair=Copy-
Type,SN=Serial-
Num,CU=CU#,CCA=CCA#
YKB203W TSO
A dynamic change was detected in an I/O configuration definition
while the YKP2B command was executing with CHECK specified for
the HS parameter.
Check the status of the device targeted by the YKP2B command, correct
any errors in the configuration or execution conditions, and then
re-execute the command.
device-number
Device number being processed when a dynamic change was
detected in an I/O configuration definition
A dynamic configuration change was
detected. DEVN=device-number
YKB204W TSO
Table 4 List of messages (message ID YKC0x)
Explanation and recommended actionsMessage textMessage ID
Invalid parameters are specified.
For details, see the reason code in the YKC099I message displayed
after this message. For reason codes, see IKJPARS in the TSO/E
Programming Services.
Supplied parameters invalidYKC000T TSO RC=48
Messages 77