HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
The license (function) will expire in n days.
To continue using this product after the expiry date, you need a
permanent license.
If function is Basic:
A permanent license for Business Continuity Manager Basic is re-
quired.
If function is CAJ 4x4 Extended CTG:
A permanent license for Business Continuity Manager CAJ 4x4
Extended CTG is required.
Your function license will expire
in n day(s).
YK9081W CON
Table 3 List of messages (message ID YKA0x - YKB20x)
Explanation and recommended actionsMessage textMessage ID
An error was detected during parameter analysis.Supplied parameters invalidYKA000T TSO
The handle value assigned to the HANDLE parameter is invalid.
HANDLE() value not validYKA001E TSO
The OP(GET) and OP(CLOSE) requests require the HANDLE parameter
to be specified.
Use the handle value returned by the OP(OPEN) request in the
YKA098I message.
HANDLE() parameter required for
this operation
YKA002E TSO
The OP parameter is missing.
Specify the OP parameter.
OP(OPEN|GET|CLOSE) option re-
quired
YKA003E TSO
An attempt to acquire the IEA494I console message, IOSHM0414I
console message, or the message specified in the MSGID parameter
of the KTCONMSG command failed. This problem might occur when
console message traffic is too high or when the KTCONMSG command
issuance interval is too long.
Buffer full; messages discardedYKA004E TSO
An attempt to acquire the IEA494I console message, IOSHM0414I
console message, or the message specified in the MSGID parameter
of the YKCONMSG command failed. This problem might occur when
console message traffic is too high or when the YKCONMSG command
issuance interval is too long.
When you receive this message, issue the YKQUERY command to check
the copy pair status.
Buffer full; messages discardedYKA004E TSO
A system error was detected.
Contact HP Technical Support for assistance.
error-type
Type of system error
SYSTEM ERROR. error-type
YKA006E TSO
The value specified in the TIMEOUT parameter is invalid.
TIMEOUT() value not validYKA007E TSO
If GET or CLOSE is specified in the OP parameter, you cannot specify
the TIMEOUT parameter.
Specify OPEN in the OP parameter, and then specify the TIMEOUT
parameter.
TIMEOUT() parameter cannot be
specified for this operation
YKA008E TSO
The value specified in the MSGID parameter is invalid.
MSGID() value not validYKA009E TSO
Messages 73