HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

DescriptionMessage textMessage ID
The requested processing could not be performed. This
device was skipped and processing continued.
Check the status of the device that caused the error,
correct any error in the configuration or execution
conditions, and then re-execute the command.
device-number-1 (character string)
Device that issued an I/O
device-number-2 (character string)
Operation-target device
If the device number of the operation-target device
is not found, **** is displayed.
code-1 (hexadecimal number)
Message type
code-2 (hexadecimal number)
Reason code
code-3 (hexadecimal number)
Error code
For details about an error code, see the description
for that error code.
code-4 (hexadecimal number)
Subcommand code
xxx (decimal number)
Command code of the command that was being
executed when the error occurred
See the description of command codes for the
KTZ201E message.
yyy (character string)
Maintenance information
volume-ID
Information that identifies the volume in which the
error occurred
Volume serial number, control unit number, and
command control address number
DASD device device-number-1(device-
number-2) management error. (Message
type: code-1 Reason code: code-2 Error
code: code-3 code-4, cmd=xxx,
pos=yyy)
KTH257E MSG TSO SC=32
RC=32 (volume ID)
The command was not issued because this device is not
supported. Use a device that is supported by Smart
Manager for Mainframe. If a scan was not performed
after the storage system microcode was replaced,
perform a scan again.
devn
Device number of the device to which the command
was issued
supfnc (hexadecimal number)
Value for the version of the hardware support func-
tion used in the device
command
Name of the command that could not be executed
The command cannot be executed because
the device (devn) is not supported. (sup-
fnc,command)
KTH410E MSG SC=12
RC=12
Messages 29