HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
EXCTG cannot be used on a storage system that has a P-VOL or uses
the Remote DKC Control Function.
Use a device
#2
that supports EXCTG. Also, if a scan has not been
performed after the storage system microcode was replaced, perform
another scan.
IFType
IFType value
#1
If this message is output while the YKLOAD command is being ex-
ecuted, the RC is 44.
#2
EXCTG is used in a storage system where the first two digits of the
IFType are X'13' or higher.
Primary device IFType does not
support EXCTG.
YKZ406E MSG
SC=36 RC=36
#1
EXCTG cannot be used on a storage system that has an S-VOL or uses
the Remote DKC Control Function.
Use a device#2 that supports EXCTG. Also, if a scan has not been
performed after the storage system microcode was replaced, perform
another scan.
IFType
IFType value
#1
If this message is output while the YKLOAD command is being ex-
ecuted, the RC is 44.
#2
EXCTG is used in a storage system where the first two digits of the
IFType are X'13' or higher.
Secondary device IFType does not
support EXCTG.
YKZ406E MSG
SC=36 RC=36
#1
Messages 203