HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
A dynamic change in an I/O configuration definition was detected
during processing of the command.
Check the status of the device targeted by the command, correct any
errors related to the configuration or execution conditions, and then
re-execute the command.
device#
Device number being processed when a dynamic change was
detected in an I/O configuration definition
A dynamic configuration change was
detected during specified command
processing. DEVN device#
YKZ370E MSG
SC=32 RC=32
The KTENV command terminated.
return-code
Return code issued by the KTENV command
KTENV command return code=re-
turn-code.
YKZ371I TSO
The YKENV command terminated.
return-code
Return code issued by the YKENV command
YKENV command return code=re-
turn-code.
YKZ371I TSO
Table 45 List of messages (message ID YKZ40x)
Explanation and recommended actionsMessage textMessage ID
The parameter indicated by param cannot be specified for a copy
group with a copy type of copy-type.
Check the copy type and the parameter.
param (string)
The parameter name which cannot be specified
copy-type (string)
The copy type specified for the copy group
param parameter cannot be spe-
cified for copy-type Copy Group.
YKZ400E MSG
SC=48 RC=48
The storage system which the command is issued onto, or the storage
system which uses the Remote DKC Control Function, does not support
the parameter indicated by param.
Use a device which supports the parameter indicated by param. Also,
if a scan has not been performed after the storage system microcode
was replaced, perform another scan.
param (string)
The parameter name which is not supported
Some of the storage systems do not
support param.
YKZ401E MSG
SC=48 RC=48
Messages 201