HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
No APID value is registered.
Correct the content of the configuration file.
dad-id
Device address domain ID
# If this message is output while the YKLOAD command is being
executed, the RC is 44.
dad-id APID is null.
YKZ235E MSG
SC=36 RC=36
#
No interface number is registered.
Correct the content of the configuration file.
dad-id
Device address domain ID
# If this message is output while the YKLOAD command is being
executed, the RC is 44.
dad-id Interface number is null.
YKZ236E MSG
SC=36 RC=36
#
The command device group identified by name is not specified.
Correct the contents of the configuration file.
name
REXX variable name
# If this message is output while the YKLOAD command is being
executed, the RC is 44.
Routelist attribute name is null.
YKZ237E MSG
SC=36 RC=36
#
Suspension initiated by YKSUSPND ATTIME is still in effect. Copy pair
operation is canceled.
Re-execute the command after YKSUSPND ATTIME processing ends.
ATTIME SUSPEND remains in place.
Pair operation process is canceled.
YKZ238E MSG
SC=36 RC=44
The specified copy group is not a Continuous Access copy group with
consistency group ID specified.
Confirm that the copy group is a Continuous Access copy group with
consistency group ID specified and is a Continuous Access copy group
for which the Open/MF Consistency attribute is not set. After that,
re-execute the command.
The specified Copy Group has no
Continuous Access Synchronous
Group.
YKZ239E MSG
SC=48 RC=48
A copy pair corresponding to the device number specified in the DEVN
parameter was not found in the copy group.
The specified pair was not found in
the Copy Group. (DEVN=P-VOL-
device-number,S-VOL-device-
number)
YKZ240E MSG
SC=48
There is no volume eligible for I/O issuance.
Check the volume status, correct errors involved in the configuration
or execution conditions if any, and then re-execute the command.
No I/O issued volume is in Copy
Group(s).
YKZ241W MSG
SC=4 RC=0
You cannot execute the YKRESYNC command to change the copy
direction before suspension, because the copy pair status is not
SWAPPING or the status of the copy pairs has not been acquired.
Check the status of the volumes in the copy group, correct the
YKRESYNC command parameter specification, and then re-execute the
command.
When executing the YKRESYNC command with the FORWARD/REVERSE
parameter, execute the YKQUERY command or YKEWAIT command to
acquire the status of the copy pairs immediately before the YKRESYNC
command.
The pair needs to be swapping, but
is not.
YKZ242E MSG
SC=48 RC=48
Messages176