HP XP7 Smart Manager for Mainframe Messages (TK916-96002, May 2014)

Explanation and recommended actionsMessage textMessage ID
Access to the REXX variable identified by name failed.
For details about the return code, see IKJCT441 in the TSO/E
Programming Services.
nnnn
Error code returned upon REXX access
REXX failure return code=nnnn
starting with variable name
YKX010E TSO RC=40
The command device definition for the storage system identified by
serial-number failed.
If multiple command devices are defined for the storage system,
processing continues.
Operate according to the I/O error messages issued simultaneously.
serial-number
Serial number of the corresponding storage system
apid
APID of the command device that failed to be defined
Storage system serial-number
Command Device Definition Failed.
(APID=apid)
YKX065W MSG
SC=4 RC=0
The route list to be processed was not found.
Check the ROUTE parameter, DAD parameter, route list definition file,
and command device definition file specified in the YKLOAD command.
Check that the information corresponding to the storage system serial
number specified in the YKBLDCMD command is set.
Necessary Route List is not found.
YKX066E MSG
SC=48 RC=48
The YKBLDCMD command terminated with the return code nnnn and
the reason code rrrr.
This message is always displayed to indicate the return code and the
reason code.
nnnn
Maximum among the severity codes returned during command
execution
YKBLDCMD command return
code=nnnn, reason code=rrrr
YKX099I TSO
Table 29 List of messages (message ID YKX1x)
Explanation and recommended actionsMessage textMessage ID
Invalid parameters are specified.
For details, see the reason code in the YKX199I message that will
appear after this message. For reason codes, see IKJPARS in the TSO/E
Programming Services.
Supplied parameters invalidYKX100T TSO RC=48
Nothing is assigned to the APID parameter.
No application id APID() supplied
YKX101E MSG
SC=48
Nothing is assigned to the CCA parameter.
No command control address CCA()
supplied
YKX101E MSG
SC=48
Nothing is assigned to the CU parameter.
No control unit# CU() supplied
YKX101E MSG
SC=48
Nothing is assigned to the DEVN parameter.
No device# DEVN() supplied
YKX101E MSG
SC=48
Nothing is assigned to the MSG parameter.
No message MSG() suppliedYKX101E TSO RC=48
Messages 145