HP XP7 Replication Manager User Guide (TK981-96013, May 2014)

Related topics
About the Add Command Devices Wizard, page 110
Setting up command devices, page 108
Editing command devices, page 320
Deleting command devices, page 321
Storage system types and volume requirements (command devices)
Volumes that meet the requirements listed here are displayed as candidate volumes in Replication
Manager.
Storage system types and requirements for using volumes as command devices
XP24000/
XP20000/
HP P9500
HP XP7
XP12000/
XP10000/
SVS200
Requirement
YYVolume not a paired volume
YYVolume not an external volume
YYVolume not a virtual volume
YYVolume access attribute must be Read or Write
YYVolume not reserved for Auto LUN
Y
1
NNot a virtual DKC
Legend:
Y: This requirement applies.
N: This requirement does not apply.
1. This requirement is applied for HP XP7 only.
Command device settings for virtual machines
The Replication Manager command device configuration function cannot be used to set a volume as
a command device if the volume has been allocated for a VMware virtual machine.
To set a command device for the virtual machine:
1. Use XP7 Remote Web Console to set the volume as a command device.
2. Use XP7 Remote Web Console to add the command device in (1) to a VMware host group and
set a path for the command device.
3. Perform VMware Raw Device Mapping, and then make sure that the command device in (1) is
recognized by the virtual machine.
User Guide 109