HP XP7 Command View Advanced Edition CLI Reference Guide (TK981-96006, May 2014)

DescriptionStatusParameter name
Over provisioning warning threshold (%)
This is a threshold value related to the over-provisioning percent.
#2
The following values can be specified when modifying the
threshold value:
For HP XP7 and P9500:
Specify an integer from 0 to 65534. You need to specify a
value smaller than the one specified for overprovi-
sioninglimit.
Specify -1 to cancel an already set threshold value.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to specify a
value smaller than the one specified for overprovi-
sioninglimit.
Specify -1 to cancel an already set threshold value.
Optional
overprovision-
ingwarning
#1
Over provisioning limit threshold (%)
This is a threshold value related to the over-provisioning percent.
#2
The following values can be specified when modifying the
threshold value:
For HP XP7 and P9500:
Specify an integer from 0 to 65534. You need to specify a
value larger than the one specified for overprovisioning-
warning.
Specify -1 to cancel an already set threshold value.
If you specify a threshold value and the over-provisioning
percent
#2
exceeds the specified threshold value, you cannot
create a THP/Smart volume.
For XP24000/XP20000:
Specify an integer from 10 to 1000. You need to specify a
value larger than the one specified for overprovisioning-
warning.
Specify -1 to cancel an already set threshold value.
If you specify a threshold value and the over-provisioning
percent
#2
exceeds the specified threshold value, you cannot
create a THP volume or assign THP volumes to a THP pool.
Optional
overprovi-
sioninglimit
#1
Device number of the logical unit(s)
Specify this parameter as a decimal number or colon-delimited
hexadecimal number in the format ww:xx:yy, where ww is the
LDKC number, xx is the CU number, and yy is the LDEV number.
ww is optional. If ww is omitted, LDKC is assumed to be 0.
Use a comma to delimit multiple values.
Optional
adddevnums
Specify this parameter when you change the type of the
THP/Smart pool.
One of the following values can be specified.
• enable: Changes the pool to a Smart pool.
• disable: Changes the pool to a THP pool.
Optional
(HP XP7
P9500)
tiercontrol
#3
CLI Reference Guide 265