HP XP7 Command View Advanced Edition 8.0.0-01 Release Notes

Creating THP volumes
In the Create Volumes dialog box, the subscription limit of the pool is not checked when the create
volumes task is registered if the following conditions are met:
• The Create Volumes dialog box is launched after a pool is selected.
• Either of the following pools exist in the storage system.
The subscription limit is set larger than the subscription limit of the selected pool.◦
◦ The subscription limit is not configured.
The create volumes task that was registered with the above conditions generates the KAIC06299-E
storage system error.
Creating multiple volumes
When a task creating multiple volumes does not succeed in the following storage systems, even if the
status of the volumes displayed in Task Details is not Completed, some volumes might be created on
the following storage systems:
• XP P9500 Storage Disk Array
• XP24000 Disk Array
• XP20000 Disk Array
• XP12000 Disk Array
• XP10000 Disk Array
If a task creating multiple volumes does not succeed, refresh the storage system that is supposed to
include the created volumes. Then check whether the volumes are created in the Open-Unallocated
volumes list of the storage system. Recreate the volumes that were not created.
XP12000/XP10000 creating multiple volumes at the same time for a CU that has no
volumes allocated to it
In an XP12000/XP10000 disk array, if multiple volumes are created at the same time for a CU that
has no volumes allocated to it, the KAIC06400-E error occurs and the volumes are not created.
First, create one volume for the CU, and after that, create the other volumes.
KAIC15001-E error message in the GUI
If the GUI displays the KAIC15001-E error message, startup of Device Manager might not have
completed successfully. The following might be the cause:
• Ports required to start Device Manager are used by other processes.
Verify the ports described in the Port settings of the HP XP P9000 Command View Advanced Edition
Software Administrator Guide are not being used by other processes.
Parity groups in the Create Volume dialog box
The following message appears if the Create Volume dialog box is opened when all of the parity
groups are reserved:
No parity groups for create volumes. Create a parity group. (KAIC16109-E)
If this occurs, wait until the task using the parity groups ends.
Important considerations 29